Stock pulley removal help

I just got a new 3.6 from zzp and Im confused on how to take off the stock pulley and put the modular system back on. Does anyone have a write up or vid?

You need a pulley puller for the supercharger.

You try and do it without it and you'll screw up the shaft.

It takes a special pulley puller to take it off

not recomended but, with an air hammer, normal 3 arm pulley puller, hammer, big screw driver, and some patience, you can get it off, my shaft is fine but and no play what so ever but again, a puller would work better, if i can find it ill post a pic of my stock pulley lol

Thrasher Supercharger Pulley Puller/Installation Tool for Rental: 3800 Performance

Spend the small amount and rent it and do it right. Renting the right tool will cost alot less than replacing the snout after you mess up the bearings &/or shaft trying to do it cheaply

^ Don't do this. Do it right lol. If the bearing weren't messed up you were lucky,

Intercooler guy neil sells these as well.

Am I going to be the first one to ask if he has the proper mods to run a 3.6? Looking at his sig, he is nowhere near what he needs to be running safely.

i had a spare m90 ($50) that i could get in 5 min if needed, but like i said, not recomended but its still running fine after 10,000 mi

oh, and a water pump pulley (pusher?) to put it back on worked fine, but that was what its for too LOL

Originally Posted by blackspike2710

Am I going to be the first one to ask if he has the proper mods to run a 3.6? Looking at his sig, he is nowhere near what he needs to be running safely.

I just installed Autolite 104s and 10.5mm wires Sunday

On a stock exhaust? Are you scanning?

Originally Posted by blackspike2710

On a stock exhaust? Are you scanning?

No but once its on Im getting the whole thing tuned. And I have a plog, crossover, rear manifold, and 3"dp going on as well

Originally Posted by crzystve42

No but once its on Im getting the whole thing tuned. And I have a plog, crossover, rear manifold, and 3"dp going on as well

Y u no get headers?

Originally Posted by blackspike2710

Y u no get headers?

Because when I bought them I was planning on only going to a 3.6 inch, not any lower. Also because Im a dumbass

Well a 3.6 is like a 3.4 on a 97-03 car. Because different blower.

So it may work, it may not, car will tell the tale.

Originally Posted by Fivefingerdeathpunch

Well a 3.6 is like a 3.4 on a 97-03 car. Because different blower.

So it may work, it may not, car will tell the tale.

Well if its my car itll take 3 tries before itll work and the other times she'll be as tempermental as a 3 year old