1. Remove throttle body wiring (IAC, MAF, TPS)

2. Remove the throttle cable and the cruise control cable.

3. Remove the vaccume line on the front of the throttle body.

4. Remove the air intake hose.

5. Remove the 3, 10mm nuts (one on top and 2 on the bottom of the throttle body.) 6. Remove the throttle control cable bracket using a 10mm socket.

7. Remove the throttle body.

8. Remove the studs in the supercharger, using vise grips.

9. Clean old gasket off supercharger and throttle body.

10. Install new longer throttle body bolts into the supercharger. (I used the old nut and threaded it on the bolt all the way to the stops, then tighted it. Then I used plyers to hole the bolt while I took the nut off.)

11. Install a gasket

12. Install phenolic spacer

13. Install another gasket

14. Install throttle body. (tighten bolts to 90 INCH pounds)

15. Reconnect electrical connections and vaccume line.

16. Reconnect throttle and cruise control cables and bracket.

17. Install air intake hose

18. Start engine and check for leaks.

If you would like to make a comment or rate this write-up, please do so here.