This is a discussion on TrannyMan95 rescued my rebuild within the Community Heroes forums, part of the Site/Club News category; I mangled the install of the teflon sealing rings on my 4T65E input / 3rd clutch hub and input shaft, ...
| |||||||
05-28-2008, 02:00 PM
| #1 |
| SE Level Member  |  TrannyMan95 rescued my rebuild I mangled the install of the teflon sealing rings on my 4T65E input / 3rd clutch hub and input shaft, because I'm too cheap to buy the right tools. Shipped the hub and shaft to tripleedgeperformance, Dave installed and sized all new seals and shipped back. One week total turnaround  Including shipping both ways, cost me less than retail on new seals. TrannyMan95 is the  of 4T65E. |
|        |
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
| |
| ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Thanks to Trannyman95 | 02BlueGT | Community Heroes | 23 | 08-24-2008 07:35 AM |
| 4t65e HD Rebuild (Question is for Trannyman95 or any other Tranny GURU) | JJ91284 | W Body 1997 to current 4 speed Automatic (4T65E) (4T65E-HD) | 37 | 05-28-2008 08:24 PM |
| Trannyman95 | SlowFiero | Community Heroes | 4 | 05-28-2008 03:52 AM |
| Love for Trannyman95! | JCGT | W Body 1997 to current 4 speed Automatic (4T65E) (4T65E-HD) | 1 | 05-06-2008 04:06 PM |
| thank you again trannyman95 | silverbullet | Triple Edge Performance | 15 | 01-24-2008 07:36 AM |
Linear Mode
