Hey guys!!!

I wanna put in 6 1/2" drivers into the doors....
What is invovled, and did you have clearance issues wiht the
window once installed?

__________________
Wiz, 85mm MAF,LS1 TB, p&p M90, SSIC, p&p LIM, 3" MPS,1.8CCRR's, 90# LS6, CC push rods, Animul valve covers, SLP headers, 3" Magnaflow, 18" Niche GT's, KYB+Eibach, Custom interior and sound.

make a spacer, or buy a plastic one from metra, I have soundstreams in mine, and no problems at all (and they are large)

__________________
Steve
'97 GTP VS cam, ZZP PCM, and not much else yet

My car had the Bose speakers in it. It had a plastic holder for the speaker that was secured to the door panel. When I upgraded to my 6.5" Memphis M speakers. I took out the plastic hold that held the 5.5" speakers and dremelled it out so it would fit the 6.5" speakers. It took a few tries to get it to sit below the section of the door skin that was rubbing against the outter part of the woofer. But once I managed to get past that, they worked fine.

I am guessing GP's without the Bose speaker package do not have those nice plastic holders???

__________________

James Shafer 2003 GP GTX St. Louis MO
1.9 Modified Rockers, TOGs, 180 Tstat, PRJ 10.4 Wires, P/P Gen 3, SLP Ram Air Hood/Wizaired CAI, Gen 1 Spoiler, 3.5 Pulley, 18" TSW Mondellos w/ AGX Struts, SSC Gen II Springs

mine had some, but they put the 6.5's against the door panel

__________________
Steve
'97 GTP VS cam, ZZP PCM, and not much else yet

Aye correct, that is the part I had to work around. I cut deep into the plastic so that the speaker would sit lower in the cradle. And I then used my dremel tool to shave off the plastic of the door skin so it would not rest against the woofer. It worked out rather nicely. Granted I had white plastic stuff all over the place before it was all said done, but it doing that made it work

__________________

James Shafer 2003 GP GTX St. Louis MO
1.9 Modified Rockers, TOGs, 180 Tstat, PRJ 10.4 Wires, P/P Gen 3, SLP Ram Air Hood/Wizaired CAI, Gen 1 Spoiler, 3.5 Pulley, 18" TSW Mondellos w/ AGX Struts, SSC Gen II Springs

mine the mounting surface was pretty thin

__________________
Steve
'97 GTP VS cam, ZZP PCM, and not much else yet

I cut the inside of the plastic housing out and made a 1" spacer for my kickers. The good thing about wood is you can sand it down at an angle for beter imaging. @ 1" I had no issues at all.

__________________
MECA SQ JL AUDIO 500/1, 300/4, 3-10w1v2, XR650-CSI, Kenwood DDX-6019 , Alpine amp and JL TR400CX center channel , 300 lbs of Dynamat.