| Register FAQ MembersCalendar SearchToday |
This is a discussion on Hedlight aiming? within the Appearance forums, part of the W Body Tech category; I recently installed new bulbs on my car, and had to take out the headlamp assembly and when i put ...
| |||||||
09-06-2008, 01:45 PM
| #1 |
| GT Level Member  |  Hedlight aiming? I recently installed new bulbs on my car, and had to take out the headlamp assembly and when i put it back in I felt like my headlights were off aim. I also think there is too much of a gap between the bumper and headlight assemblies. Does anyone know how I can fix both of these problems?
__________________ 2000 Grand Prix GTP K&N FIPK2 CAI : ZZP 3 INCH DOWNPIPE : SLP POWERFLO CATBACK : ZZP 1.0 PCM. Running 0* KR 60,000 miles |
|        |
|
09-06-2008, 08:14 PM
| #2 |
| SE Level Member  | Re: Hedlight aiming? Did you put the headlights back in the right way? The plastic on the bottom of the headlight need to slide into the support. Its that not in the headlight will have a gap on the bottom. |
|
| |
|
09-07-2008, 09:14 AM
| #3 |
| GT Level Member | Re: Hedlight aiming? im pretty sure i did but i will check again to make sure, thanks
__________________ 2000 Grand Prix GTP K&N FIPK2 CAI : ZZP 3 INCH DOWNPIPE : SLP POWERFLO CATBACK : ZZP 1.0 PCM. Running 0* KR 60,000 miles |
|
| |
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
| |
| ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tech Tip Projector General Info (Aiming, PL flash, High/Low, Pics, etc.) | LowlyfeGTP | Appearance | 12 | 05-15-2008 12:49 PM |
Linear Mode
