Trannyman I have two valve body questions. Is the 3-4 accumulator valve and the 2-3 accumulator valve layed out right with the red spring going into the plug and the plug facing the right direction. the right direction as well. I believe it looks right but just want to make sure.
I had a trans shop ream my AFL bore (channel plate), TCC circuit, and my Forward/Reverse boost valves. I went ahead and purchased all the Sonnax anodized valves withe the surecure kit and I was looking over their work when I realized I wasn't quite sure if they installed the TCC Regulator apply valve bore plug. Is that metal clip they used for the TCC control valve alright to be left there (it looks like it would prevent movement), or am I suppose to remove it?
Does it look like its installed right, I have two plugs (I didn't give them mine, so they gave me one of theirs. I have two of them in my box, and I'm not exactly which one I should use. I installed the plug with the blue o-ring with the oring going into the bore first. The sonnax TCC sleeve hit the valve body end and also hits the bore plug so that leads me to believe its installed ok.
Part of my New Sonnax valves, some are already installed. I dropped probably $500 on the valve body between sensors and new valves which is overkill no doubt, but it should be great for at least 150k or so, at least I hope
Also when I had the channel plate at the trans shop, they removed by 4 accumulator piston and I'm not quite sure if I have the pin in right. I know the springs are OK as those are from the transgo kit.
